Grasshopper

algorithmic modeling for Rhino

About intersections of geometry (cylinders)

I made the lines with using Voronoi and cylinder.
I would like to make it as a solid or mesh like the picture at the very bottom. (I guess the solid is better for low size file, since I would save it as an .iges format which is pretty light)
However, for an intersection (I checked with a star), there are a little cavity and few overlapped areas by the cylinders. So, when I save it as an .iges file, the overlapped areas become a bad geometry. 
Some guys here made many examples for me, but most of them are too complicated that my computer cannot make it. Especially, Cocoon mesh was a great tool, but it doesn't work with a larger sample due to low ram of 8gb. (My company cannot afford me more... sigh...)
Well, can I eliminate the overlapped and cavitated geometry ?

Views: 658

Replies to This Discussion

Permalink Reply by mark zirinsky on August 25, 2015 at 9:28pm

add a sphere at each node. solid subtract the sphere from each pipe. then add the sphere back in

Permalink Reply by Marcin Nowak on August 8, 2016 at 1:54pm

Did U do it? I had the same problem but no resoult :(

Permalink Reply by Chapulin Colorado on August 8, 2016 at 2:09pm

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service