Grasshopper

algorithmic modeling for Rhino

Surface/Brep between closed non planar curves

I was wondering if it is at all possible to create a surface/brep in between a bunch of closed non planar curves? I playing with this for sometime now but nothing works... any ideas?

Views: 678

Attachments:

Replies to This Discussion

Permalink Reply by Oliver Hampel on July 19, 2016 at 2:34pm

I did... but I needed to offset each closed curve slightly differently which left the base surface useless to split...

Thank you

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service