Grasshopper

algorithmic modeling for Rhino

Loft between many curves

Basically What I have done is applied circles to points

- moved points based on a series parameter on z axis

- scaled those moved circles and then moved them again on z axis

- scaled the second set of circles and moved them again

so I have 3 sets of circles with different dimensions that I want to loft together. I want to essentially create lofts of each "group" of circles to create a series of loft.

Thank you

Views: 696

Attachments:

Replies to This Discussion

Permalink Reply by Hyungsoo Kim on June 5, 2016 at 10:22am

Like this?

Attachments:
Permalink Reply by Mikelangalo on June 5, 2016 at 2:13pm

Hi there,

Thank you very much for your reply, however thats not exactly what I needed. 

I updated the last bit of the script as I think that I may of done it wrong in the original post.

Also I have added a photo of what kind of geometry I wanted to achieve, if you could help me that would be greatly appreciated

Attachments:
Permalink Reply by Hyungsoo Kim on June 5, 2016 at 3:05pm

Loft needs your 3 circles consecutively and they need the same hierachy of data structure.

And your source surface is a trimmed one, so many null points caused by it.

You should clean the "Divide Surface" data.

Attachments:
Permalink Reply by Mikelangalo on June 5, 2016 at 3:14pm

ah I see, that has actually helped me a lot, thank you very much! 

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service