Grasshopper

algorithmic modeling for Rhino

overlapping planer curve, how can i rebuild to one curve

hi there mighty hoppers

i have curves, planar curves. which are sometimes overlapping, due to the intersection of plane and Brep. my brep is made of mostly patches and i think this is the reason why the result is not always one planar curve.

the end/start points are over lapping. and i wish to remove the excessive part and create the curves as tangent as possible (so i dont deform them)

any ideas?

thnx

Views: 551

Replies to This Discussion

Permalink Reply by AJ on May 25, 2016 at 12:17am

Attachments:
Permalink Reply by AJ on May 25, 2016 at 2:16am

im on it. thnx Tom

Permalink Reply by AJ on May 25, 2016 at 4:22am

managed to do this

the fit curve component is great, i struggled with small deformation of the input curve, so i had to rebuild them.

here is what i have done

Attachments:

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service