Grasshopper

algorithmic modeling for Rhino

loft a series of curves to one curve

Hi,

Quite simple but quite difficult question i think. Not sure if there's a simple fix.

I'm trying to loft a series of curves all to a single curve, I can't seem to figure it out.

I thought moveedge in rhino would have been the trick but that failed also. 

Thanks

J

Views: 395

Attachments:

Replies to This Discussion

Permalink Reply by jeroenvanlith1 on April 22, 2016 at 5:59am
Hey, you have to duplicate the single curve with the list length of the series of curves. Then it works!
Permalink Reply by Mahdiyar on April 22, 2016 at 7:01am

Hi James, You can simply loft a series of curves to a single curve by using the [Weave] component.

But if you want to get better result, you will need to adjust the seam of every pair of curves.

 

Attachments:

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service