Grasshopper

algorithmic modeling for Rhino

Creating Faces From Points

NOOB here, Im trying to create a triangulated roof structure. I have isolated the points i need, so i can manipulate them individually but i just cant seem to loft them together when i make lines out of them. 

i  also tried  delauney between points but this too gives me undesirable results.

Am i on the right track?
GRACIAS!
 

Views: 714

Replies to This Discussion

Permalink Reply by Jeroen van Lith on April 17, 2016 at 12:01am

Hi Francisco, 

Why are not all the cornerpoints previewed in your display? Try flattening the points list and then using the delaunay component. From there you can create nurbs geometry again. Hope this works! 

Attachments:
Permalink Reply by peter fotiadis on April 17, 2016 at 1:36am

Also

Attachments:
Permalink Reply by Francisco Diaz on April 19, 2016 at 8:49am

Thanks for your reply!im going to work on it a litlle more and see the different results i get.

Permalink Reply by Francisco Diaz on April 19, 2016 at 8:52am

Hey thanks a lot for your reply.!!
I think my corner points are previewed. or what exactly did you mean? 

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service