Grasshopper

algorithmic modeling for Rhino

Finding the circumscript circle

hi guys,

I need to find a circle inside of each subsurface of this surface

I've attached the grasshopper file and the rhino file.

THe thing is... I'm pretty pretty close... but if you zoom it, there are some of them which

are not inside of the subsurface.. Maybe there is a little detail that I'm forgetting...

Can anyone help me? Thanks!

Views: 484

Attachments:

Replies to This Discussion

Permalink Reply by jeroenvanlith1 on April 7, 2016 at 7:26pm
Hey,

you can project the surfaces and centerpoints, in order to get the right distances for the curveCP to get the circles fitting the surfaces in top view. See attached file. Good luck!
Permalink Reply by branca leibovich on April 8, 2016 at 1:25am

I did the same with an elipse but the elipse is parallel to base plan... I need them faced to the surface... can you help me?

Permalink Reply by jeroenvanlith1 on April 7, 2016 at 7:27pm

Attachments:
Permalink Reply by branca leibovich on April 7, 2016 at 11:39pm

Thank you so much!!!

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service