Grasshopper

algorithmic modeling for Rhino

Drawing finger joint curve

I have points in two branches A and B and I want to create a curve so the result will be similar to what is found in finger joints following this order: 1B, 1A, 2A, 2B, 3B,3A,4A, 4B,5B, 5A...as in the attached image, any help about how to do this? 

Views: 1919

Attachments:

Replies are closed for this discussion.

Replies to This Discussion

Permalink Reply by Hyungsoo Kim on April 2, 2016 at 3:29am

Hi.

This could be a way. Best.

Attachments:
Permalink Reply by isbahes on April 3, 2016 at 4:09am

Thank you very much !

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service