loft interpolate

Replies to This Discussion

Permalink Reply by Fred Becquelin on March 3, 2016 at 5:32am

Hi deniz,

1) do not graft the input for the loft component, it needs a LIST of curves

2) There are eleven "L1" extension distances, for 10 curves. you need to cull the last one too, or use short list component.

additionally

3) Easier is to put -1 into the cull index, it'll cull the last item of the list.

3) Prefer the Evaluate Length component rather than PointOnCurve... Well that's just me talking.

Cheers,

Fred.

Permalink Reply by deniz ada on March 3, 2016 at 5:48am

Thanks removing the last one by using cull, the loft problem can be solved.
But I can not use the Evaluate Length component for interpolation.

Permalink Reply by Fred Becquelin on March 3, 2016 at 6:14am

What do you mean, you cannot? It's the same, just "better practice" imho.

Permalink Reply by deniz ada on March 3, 2016 at 7:31am

 Thanks ,

 I think it is the same but   the interpolate cannot  perform.

Attachments:

• loft interpolate.gh, 15 KB

Permalink Reply by Fred Becquelin on March 3, 2016 at 8:11am

Look at my picture!! Where did I insert the second Cull???

You still have 11 curves out from extension, because you still have 11 length values in L1.

Same problem, same solution...