Grasshopper

algorithmic modeling for Rhino

mesh "extra" naked edge

As part of a large process a mesh is made from faces between a polygon and a scaled version. In the attached case one of the edges between the two polygons is marked as naked and I can not figure why. If the polygon is moved the effect goes away. As far as I can determine the vertices are identical - 

 

Views: 839

Attachments:

Replies to This Discussion

Permalink Reply by Hyungsoo Kim on February 21, 2016 at 11:04pm

Hi.

Join mesh is not enough. You should "weld" joined mesh.

Check attached. Meshedit" plug-in needed.

Attachments:
Permalink Reply by Jissi Choi on February 21, 2016 at 11:13pm

It seems to be a problem with the float operation..

(I don't know why the Mesh use Point3f rather than Point3d..)

If you don't mind that identical vertices are merged..

the Mesh WeldVertices component (not WeldMesh) would be a solution..

It may be found in MeshEdit plugin..

https://sites.google.com/site/utotoolswiki/meshedit

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service