Grasshopper

algorithmic modeling for Rhino

Set Zone Loads - Infiltration

Hey there, 

I have a few questions regarding the infiltration setting in the Honeybee Set Zone Loads component.

Can anyone tell me how the infiltration is specified in the component, is it m3/s per m2 floor area at 50Pa or at ambient pressure?

and if it is at ambient pressure, does anyone have the equation(s) for how to convert it to 3/s-m2 at 50Pa?

Views: 226

Replies are closed for this discussion.

Replies to This Discussion

Permalink Reply by Abraham Yezioro on February 13, 2016 at 3:36am

Nickolaj,

Check this discussion.

On my last response you can find an example for the 50PA you are asking for. "Normally" the calculation is for ambient pressure.

-A.

Permalink Reply by Nickolaj Feldt Jensen on February 15, 2016 at 10:54am

Hey Abraham, 

Thank you so much, it worked like a charm :)

- Nickolaj

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service