Grasshopper

algorithmic modeling for Rhino

How to constrain points on a surface

Hello everybody,

this is my first post and I need help for an issue.

i have create honeycombs on a sruface and adding an attractor after.

I can't find the way to constrain my points on the surface. From what I have already watched, kangaroo should be an answer, but there are few tutorials with kangaroo 2.

My surface is panelized with Lunchbox.

thanks for your help.

Views: 596

Attachments:

Replies to This Discussion

Permalink Reply by Hyungsoo Kim on February 14, 2016 at 12:03pm

Hi.

You did'nt panelize your initial surface yet. You just have generated another hexagonal cells based on the surface dimension. This is a different approach. Best. 

Attachments:
Permalink Reply by Guewen on February 14, 2016 at 12:41pm

Thanks kim for your reply !

I like the way you panelize the surface and i will go your way.

But, my worry is about keeping the surface rectangular.

regards,

Permalink Reply by Hyungsoo Kim on February 14, 2016 at 1:02pm

I suppose your intension is to keeping the rectangular boundary, if so, you can use "Trim with Region"

Attachments:

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service