Grasshopper

algorithmic modeling for Rhino

Question about curve centre and dispatch points

Hello,

I am new to grasshopper and I am encoutering a problem when playing with this geometry that I created from a series of curves. I want to rotate the curves at the end to create a twist form for the tower; however, I notice that all my curves which created from centre of geometry and a dispatched points were not in alignment to create a planar curve. I don't know how I could fix this...is there a component that can give me the centre of a curve?

Thank so much to whoever could give me some insight!

Views: 556

Attachments:

Replies to This Discussion

Permalink Reply by Hyungsoo Kim on February 5, 2016 at 1:33am

Hi.

You'll need "Data Maching". See red group. Best.

Permalink Reply by Hyungsoo Kim on February 5, 2016 at 1:41am

File..

Attachments:
Permalink Reply by Winnie on February 6, 2016 at 1:14pm

thank you so much for help!

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service