Flip

Replies to This Discussion

Permalink Reply by Evan C on November 4, 2010 at 12:53am

v.8.0001 by the way.

Permalink Reply by Andrew Kudless on November 4, 2010 at 1:26am

Send a negative value to the offset. Use a gate toggle to flip if you use a neg or pos number. I typically add these components before an offset. Of course, this becomes less useful if you are offsetting lots of curves and some are offsetting in the "right" direction and some are not. Then you need to figure out a rule for the offset (e.g. If the offset curve has a longer length than the source curve, offset in the opposite direction).

Permalink Reply by paloma on December 16, 2010 at 9:09am

Do you say with a f(x) component?

If it is so, how would you write the expression?

 

(I´m new in this, thanks for everything)

Paloma

Permalink Reply by Chris Tietjen on December 16, 2010 at 10:49am

Here's one way.

Chris

Attachments:

• Offset Toggle.ghx, 49 KB

Permalink Reply by Chris Tietjen on December 16, 2010 at 11:06am

I just noticed that if you change the slider type for the toggle to 'Odd numbers' it will be a true toggle without stopping on '0'.

 

Chris

Permalink Reply by paloma on December 16, 2010 at 1:11pm

thanks!!

Permalink Reply by Chris Tietjen on December 16, 2010 at 3:15pm

Hi Paloma,

It turns out that there is a component called a 'Boolean Toggle' in the Params>Special menu.  I wasn't aware of that.  It's in the upper left hand corner.

 

Chris

Permalink Reply by kleerkoat on November 4, 2010 at 6:32am

at first I was a little irked with this change, but now it is much more reliable, atleast in the definitions i use it in.