Grasshopper

algorithmic modeling for Rhino

Trim curves that are outside a form in Grasshopper?

Question.. i want to cut the curves that are outside a form just like the fonction trim in autocad? is there a simple way to trim or split or itnersect curves with other curves or curves with lines? i dont find a solution so far.. I did the Curve/Curve than the Shatter component and finaly the Cull Pattern Component to remove all the parts that I don't want but it's not working very good. I probably did it the wrong way. I went to many differents sites to figure it out but still don't get the result that I want.

Thanks

M.P

Views: 5100

Attachments:

Replies to This Discussion

Permalink Reply by Hyungsoo Kim on December 25, 2015 at 8:58am

Hi.

Try to use "Trim with Region" component.

Attachments:
Permalink Reply by marianne pasqueli on December 26, 2015 at 7:55pm

thank u very much!

Permalink Reply by Joseph Oster on December 25, 2015 at 10:36am

I didn't look at your files but did you see this one a week ago?

How can I get curves inside a domain curve?
http://www.grasshopper3d.com/forum/topics/how-can-i-get-curves-insi...

Attachments:
Permalink Reply by marianne pasqueli on December 26, 2015 at 7:55pm

thank u!!

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service