Grasshopper

algorithmic modeling for Rhino

plane between offset

Hello people, 

I'm trying to make a plane in between two curves (offset and trimmed) and try to match it to a point attractor.

Basically I want the edge offsets the least when it is the closest to the point.

The problem I am facing is when I put the point at the centre of the shape, the plane works fine (using either loft or ruled surface component) but when I move the point to a other place the plane does not work as I wanted it to be.

I am not sure what is the problem. I have attached images of the problem and the files. 

Any help will be greatly appreciated. Cheers.

Views: 379

Attachments:

Replies to This Discussion

Permalink Reply by Pieter Segeren on December 5, 2015 at 2:13pm

Hi Aslan, I think you want to use BoundarySurface (Surface > Freeform tab) instead of the RuledSurface:

Permalink Reply by Aslan Adnan on December 5, 2015 at 2:16pm

Hi Pieter, thank you so much! it works like a charm! 

Permalink Reply by Pieter Segeren on December 5, 2015 at 4:07pm

You're welcome Aslan. I simplified the definition a bit - hope you can follow the logic I thought was logical...

Attachments:

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service