daylight autonomy, continious daylight autonomy,useful daylight illuminance

Replies to This Discussion

Permalink Reply by Mostapha Sadeghipour Roudsari on November 21, 2015 at 10:37am

Yes. Look for "Honeybee_Read Annual Result I"

Permalink Reply by meeee on November 21, 2015 at 10:59am

tnx I visited the page but I didn't understand anything!

is it pyton?

I want sth like DF component in honeybee

Permalink Reply by Mostapha Sadeghipour Roudsari on November 21, 2015 at 5:42pm

Hi Meeee[?]. Honeybee_Read Annual Result I is a component. To calculate DA, CDA, etc you need to run an annual analysis. Here is an example that shows the process.

Permalink Reply by meeee on November 21, 2015 at 11:14pm

Dear Mostapha

Tnx alot

Permalink Reply by StacyS on May 5, 2017 at 6:53am

Hi Mostapha, Thanks for the example. Here windows are defined by window-to-wall ratio; is there a way to define windows as geometry at where they are on the facade?

Permalink Reply by Abraham Yezioro on May 5, 2017 at 7:42am

Look at this hydra example to see how geometry was defined.

-A.

Permalink Reply by StacyS on May 5, 2017 at 9:02am

Thanks Abraham! I am curious why we need to include glazing in the "Generate Zone Test Points" component, _HBZone.

Also, what's the best way to set up _HBZone? I have a two-storey building, when I used the approach Mostapha provided, the daylight autonomy results only show on the 1st floor. 

Thanks!

Permalink Reply by Abraham Yezioro on May 5, 2017 at 11:27am

I'm confused with your question. I understood you want to do a daylight simulation. For that you need to define a test area (test points) where the calculations will be performed on.

If you want both floors, you need to input two (or more) test areas, so the test points will be created and calculated.

-A.