Grasshopper

algorithmic modeling for Rhino

PANELING CURVE

Hello everyone, 

I'm trying to arrange a geometry to flow on curve. I created a simple definition that does that, however, the final result appears in a distant location far from my original curve which was created in rhino. I'm trying to find a way to place my baked definition exactly on my original curve. If it is not fully understood, I think my attached files will explain it better.

please help!

thx
 

Views: 310

Attachments:

Replies to This Discussion

Permalink Reply by Hyungsoo Kim on October 31, 2015 at 11:27am

In this case "orient" is better than "Box Morph"

Attachments:
Permalink Reply by jonnyginger89 on October 31, 2015 at 11:55am

THANK YOU SO MUCH Hyungsoo Kim!

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service