Grasshopper

algorithmic modeling for Rhino

Combining two Cull Patterns

Hi Guys, 

I am having difficulty combining two Cull Patterns that I have. The images below represent the effect I have generated (thus far) by using two cull patterns for a single series of meshes. My aim is to combine the two cull patterns so that I can ultimately have the two indents in the wall occurring at the same time 

This is the Formula I have at the moment. 

 

Sorry if this re-asks for information that is already covered on the forum, I have looked through the forum trying to understand 'sifting' and 'combining lists' but it is still beyond me.

Thanking you in advance

Joel 

Views: 1564

Replies to This Discussion

Permalink Reply by Canhui Chen on October 15, 2015 at 6:11pm

Hi Joel

it seems to me that you are trying to cull the pattern with multiple attractors?

Here are some tips, instead of doing the distance calculations separately, you can get the average value then use that one number to cull.

I have attached the file as well.

Attachments:
Permalink Reply by Joel Falconer on October 15, 2015 at 7:28pm

Thank you so much ! This is a huge breakthrough for me. It worked perfectly, and solved a lot of other issues I was facing.  Thank you so much !!!

Regards

Joel

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service