Using Copy trim on intersecting mobius strip

So I have a rectangular surface that is unrolled from a intersecting mobius strip. I punched holes on it and used copy trim to remap it on the intersecting mobius strip. In plan it seems like it should work with the half length of the distance between circles on both ends, but when I remap it on the the actual mobius strip, where the start and end meet have a longer distance between two circles than the other parts.

Can someone tell me what is happening and provide some suggestions?

Need help!

Attachments:

intersecting mobius strip.3dm, 49 KB
intersecting mobius strip.gh, 14 KB

Replies are closed for this discussion.

Replies to This Discussion

Permalink Reply by Joseph Oster on October 7, 2015 at 8:21pm

Much better to keep this project in one thread! I don't think my unroll was correct and am not sure yet that your Möbius strip accurately represents the image you posted. Also not sure that unrolling is even necessary. Willing to work on it but multiple threads isn't a good idea.

Permalink Reply by Yoonho Oh on October 7, 2015 at 8:25pm