Grasshopper

algorithmic modeling for Rhino

How to Loop a List

Hi All,

Sorry if this is too basic, I am sure this has been answered somewhere else somehow I wasnt able to find it...

I have a set of objects (surfaces) which I want to extrude using a list of values. There are more objects than values in the list and I would like the operator to go back to the begining of the list until there are no more objects to extrude. Normally grasshopper just repeats the last value for the remaining objects. Is there a way whithin gh to make this loop? Do I need to set up a function (condition) or do I need an additional plug-in? I was checking out hoopsnake but I'm not sure that would apply in this situation.

(see definition attached)

Thank you in advance,

Views: 8949

Attachments:

Replies to This Discussion

Permalink Reply by Daniel González Abalde on September 12, 2015 at 4:15am

Attachments:
Permalink Reply by Rolando Rodriguez-Leal on September 12, 2015 at 5:29am
Thanks Daniel seems that you nailed it... how do I get the D L component?
Permalink Reply by Daniel González Abalde on September 12, 2015 at 5:40am

You have uploaded the file... But it is called "Repeat Data".

Permalink Reply by Rolando Rodriguez-Leal on September 12, 2015 at 11:04am

Thank you Daniel, that was exactly what I was after.

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service