Wonky Surface Normals on Hypar

Replies to This Discussion

Permalink Reply by Hyungsoo Kim on September 2, 2015 at 1:05am

Hi.

I think this method is more reliable.

Attachments:

• hypar_re.gh, 26 KB

Permalink Reply by Bradley Bowers on September 4, 2015 at 11:13am

Awesome interpretation Hyungsoo, and the use of the NURBS instead of Interpolate was a great add on. This has set me on the right path thank you!!!!!

Permalink Reply by Bradley Bowers on September 6, 2015 at 12:30pm

Hyungsoo, 

So I made some adjustments to the geometry and the curves, and now there are issues with the WEFT pattern. I get one side to work perfectly, but can't get the inverse . . . could you take a look and tell me what you think could be the problem????

Thank you, 

Attachments:

• halfway_there.gh, 24 KB
• halfway_there.3dm, 109 KB

Permalink Reply by Hyungsoo Kim on September 6, 2015 at 3:16pm

I can't fully understand what are you going to achieve, but all you need to do is matching data.

Attachments:

• halfway_there_re.gh, 25 KB

Permalink Reply by Bradley Bowers on September 8, 2015 at 2:11pm

Okay so I sorted out the data matching to get the appropriate weaving of the lines! There were some issues that still needed sorting out . . . The first .jpg is what I want to create. And I cannot figure out how to create the strips (like in the .jpg)

I am trying to control the width of the strips and the thickness, but first forming the strips is a challenge hahaha

Attachments:

• halfway_there.gh, 49 KB
• CAVIAR20_FrankGehry_HighStickingChair_d1_S9A0070_grande.jpg, 77 KB
• halfway_there.3dm, 109 KB

Permalink Reply by Hyungsoo Kim on September 8, 2015 at 4:29pm

You can check this  this