diagrid curve thickness for construction

Hi!

I created a diagrid between multiple curves (see simplified attached file).

The diagrid is now only consisting out of curves. I want the curves to gain thickness.

The diagrid is for a façade, so it is going to be the construction of the façade. I want to sweep a construction profile over the lines (rectangle).

My question is, how can I achieve that the lines are becoming a construction with thickness?

I hope someone can help me with this, and is it possible to use any geometry for this?

Another question, when I have the straight construction, how can I round the corners of by the nodes?

I hope someone can help me with this!

Thanks in advance!

Maria

Attachments:

diagrid lines.gh, 5 KB

Replies to This Discussion

Permalink Reply by Joseph Oster on July 10, 2015 at 4:53pm

Did you try 'Pipe'?

Would be easier to look at your code if you can internalize the diagrid so 'LunchBox' isn't needed?

Permalink Reply by Maria-89 on July 10, 2015 at 5:05pm

Yes i tried using the pipe option, however i want the section to be a rectangular shape, and not a circle.
You mean only the lines without using lunchbox?
I know you can use the sweep component to sweep a surface over a line.
But how can you control that surface when the curves arent straight?
Is there a way to apply a constructive section to a line?

RSS