Grasshopper

algorithmic modeling for Rhino

Sort Point Index Map

Super basic question although for some reason can't seem to figure it out.  I am using the sort point function on the centroids of and an area, and now I want to the area geometry to match same locations in the list.  The sort Points components outputs the new index location for the sorted points.  What the best way to get the area geometry to match those locations.  The sort list component doesn't seem to work.  I was looking for something that would allow me to set the index value of an item in a list can't seem to find it.

Views: 1878

Replies to This Discussion

Permalink Reply by Joe Allberry on June 3, 2015 at 9:41am

Attach the index list to a "List item" component, where the list (L) is your geometry (surfaces).

Permalink Reply by Dennis Nelson on June 3, 2015 at 9:44am

Duh.  I new it was simple.  For some reason I was thinking it was only used to retrieve an item, which is what it's doing but in the order I want it.  Thanks for the help.

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service