prob with kangaroo definition

Replies to This Discussion

Permalink Reply by Daniel Piker on November 2, 2010 at 3:19pm

See the attached file for a fixed version. The only thing missing was to connect the SubCrvs into the Springs input.
I also increased the damping a bit so it reaches equilibrium without too much bouncing about.

Hope that helps

Also - for any future Kangaroo questions, there is now a dedicated forum here on this site:
http://www.grasshopper3d.com/group/kangaroo

Attachments:

• catenary_kangaroo.ghx, 233 KB

Permalink Reply by pyrit on November 2, 2010 at 3:48pm

thank you very much, appreciate the help.