Grasshopper

algorithmic modeling for Rhino

Irregular patterning using a grid

Hi, I'm trying to develop a pattern for a feature wall and don't know the right methods to achieve it - so any help is appreciated. The description is below and the start of a definition is attached.

I'm looking to use a rectangular grid as the framework for this pattern - I'd like to have the corner points of the rectangular move inward by a random (range) both in the x and y direction. I don't think it's terribly hard to do, but I can't seem to get the results I'm looking for

Here's what I got so far...

Views: 683

Attachments:

Replies to This Discussion

Permalink Reply by Shridhar Mamidalaa on April 30, 2015 at 10:46am

I guess this helps.

Attachments:
Permalink Reply by Shridhar Mamidalaa on April 30, 2015 at 10:51am

Another variation 

Attachments:
Permalink Reply by zip7 on April 30, 2015 at 11:08am

This is helpful - thank you very much. If anyone else has any solutions too, I'm always interested in different ways to achieve the same results...

Permalink Reply by Michael Pryor on May 5, 2015 at 7:20pm

Permalink Reply by zip7 on May 7, 2015 at 9:47am

Neat! Thanks!

Permalink Reply by Kyle Faulkner on May 6, 2015 at 4:54pm

Here's my take

Permalink Reply by zip7 on May 7, 2015 at 9:47am

Cool - thank you! 

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service