Grasshopper

algorithmic modeling for Rhino

Grid rectangular pipe - how to fix it?

Hello,

I have 3 intersecting lines and I'm trying to create a rectangular pipe on them. I have two issues that I can't find how to solve:

1. The plane normal in z-axis is rotated

2. The end points of the lines are used as corner points for the rectangles, while I want them to be located in the centre.

I have uploaded both the Rhino and Gh files. Thank you very much, any help is much appreciated.

Views: 1154

Attachments:

Replies to This Discussion

Permalink Reply by VM on May 5, 2015 at 4:00am

Hi 

You should work a little bit on rectangle orientation. I tried the solution below. Hope this helps.

Attachments:
Permalink Reply by Pieter Segeren on May 5, 2015 at 4:12am

Hi Leonidas, here's another approachEdit: you may want to use expression -x on the ConstructPlane X or Y input...

Attachments:
Permalink Reply by Leonidas Leonidou on June 1, 2015 at 1:59am

I'm replying a bit late, but thank you very much for your help!

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service