Grasshopper

algorithmic modeling for Rhino

Evaluate point distance and cull

I'm trying to divide a surface with points, and then cull any points that are closer than a certain distance - I feel I'm close - but can't quite figure it out; attached file. Any help is appreciated. Thanks, Michael

Views: 2527

Attachments:

Replies to This Discussion

Permalink Reply by nikos tzar on April 27, 2015 at 11:55am

Hello Michael,

Closer than a certain distance from each other?

If so you could use the [Cull Duplicates component] with a slider for tolerance (and right-click on it and select "leave one"):

Permalink Reply by zip7 on April 27, 2015 at 11:57am

Great, I think that's all I needed. Thanks very much. 

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2025   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service