Grasshopper

algorithmic modeling for Rhino

extrude point with distance

Hi,

In the last few days I used circle packing that I found on internet, but I can't make a extrude point to the center with certain distance and also I can't make it in layers, in other words, imagine that each circle need some thickness to create a scale model in cardboard, like the image but in cone form.

Thanks in advance,

Ulises

Views: 728

Attachments:

Replies to This Discussion

Permalink Reply by Xavier Delanoue on April 20, 2015 at 8:41am

Hi you can try this,

Better than an extrude point to the center you can move your circles according the vector from their center point to the center point of your sphere. If you connect a series to your move you can give a thickness (your step) and a number of layer (your count).

Best,

Xavier

Attachments:
Permalink Reply by Ulises Cordoba Cano on April 20, 2015 at 7:21pm

nice, let me try it

Permalink Reply by Ulises Cordoba Cano on April 20, 2015 at 7:36pm

Ok, the circles are crashing between them. Because these circles need to be small

Attachments:
Permalink Reply by mark zirinsky on April 20, 2015 at 8:07pm

try setting your extrude distance to, say, 1/3 of the circle diameter. 

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service