Place point on Planar Surface Centroid.

Hi!

I edited the post to asking you a few tips, you know recycling and stuff. (So, the answer of Hannes Löschke is to a previous question, now deleted)

I'm trying to place a Planar surface on differents points, but i want that the point could be the centroid/center of the planar surface not its origin?.

Is it possible?

Attachments:

definition.png, 264 KB
Move surface to point.png, 40 KB

Replies to This Discussion

Permalink Reply by Manuel Alejandro on February 8, 2015 at 3:40am

Permalink Reply by Hannes Löschke on February 8, 2015 at 3:04pm

Assuming, you either know how to create a hyp-par Surface in GH or know how to reference a hyp-par surface from Rhino, there are several components to generate a regular UV-grid. One is Divide Surface.

I suggest, you start off by reading the grasshopper primer.

Permalink Reply by Manuel Alejandro on February 8, 2015 at 4:34pm

Thanks. I'm new on Grasshopper, and well, i've got ton of questions.

And yeah, i used a 4PtSrf, and then Isotrim, and is working very well.

Thanks again for the reccomendation, i did not know about the existence of that book. :3

Permalink Reply by Manuel Alejandro on February 9, 2015 at 1:21am

I edited the post to asking you a few tips, you know recycling and stuff. (So, the answer of Hannes Löschke is to a previous question, now deleted)

RSS