meshing for triangular surfaces with the same mesh-density

Replies to This Discussion

Permalink Reply by Daniel Piker on February 3, 2015 at 6:47am

Try this definition (you'll need the latest Kangaroo installed, which includes this MeshMachine component)

Attachments:

• remesh_example.gh, 11 KB

Permalink Reply by Zoltan Simon on February 3, 2015 at 8:23am

When I install latest kangaroo 099, I got an error massage

But I don't really understand, why is it warning me.. the plankton.dll is also there (see attached)

Attachments:

• Screen Shot 02-03-15 at 04.21 PM.PNG, 51 KB

Permalink Reply by Zoltan Simon on February 3, 2015 at 9:47am

Daniel,

now I tried yours.. the boundary component works in 1 plan..(see attached the pictures)

If I use surface, or lines in 3d, the mesh will be more dense in 1 corner too :-(

Any idea, how can I get same mesh distribution?

Thank You

Attachments:

• Screen Shot 02-03-15 at 05.43 PM.PNG, 256 KB
• Screen Shot 02-03-15 at 05.41 PM.PNG, 496 KB

Permalink Reply by Daniel Piker on February 3, 2015 at 9:53am

Hi Zoltan,

In those images the remesher has not actually been run.

In my definition I had set the bottom 2 inputs as shown

(Sorry - I set them as internal inputs, so I can see how the confusion arose)

What this does is initialize the meshing and run 25 iterations.

Permalink Reply by Zoltan Simon on February 4, 2015 at 12:44am

Good Morning,

it works perfectly. Thank you for the support

Attachments:

• Screen Shot 02-04-15 at 08.42 AM.PNG, 373 KB

Permalink Reply by Zoltan Simon on February 3, 2015 at 11:07am

Looks great..thanks..I will try it in the morning

Permalink Reply by Zoltan Simon on February 3, 2015 at 7:13am

Thanks Daniel,

I have to refresh my kangaroo..
I will give my feedback later, but your picture looks exactly what I intended to get..thx

Zoltán

Permalink Reply by Zoltan Simon on February 3, 2015 at 8:24am

the error massage is (attached)

Attachments:

• Screen Shot 02-03-15 at 04.19 PM.PNG, 19 KB

Permalink Reply by Daniel Piker on February 3, 2015 at 8:40am

Have you checked that all the dll files are unblocked?

Permalink Reply by Zoltan Simon on February 3, 2015 at 9:18am

Thank You Daniel, finally I found my problem..

the plankton.gha file was not copied into the correct position and was not unblocked

Thanks for the support