Displays the angles

Replies to This Discussion

Permalink Reply by David Rutten on January 11, 2015 at 5:14am

Can you post a file that doesn't require Panelling Tools components? Perhaps just internalise or bake the geometry you wish to measure.

Permalink Reply by Gotzman on January 11, 2015 at 5:25am

David, Yes of course replace the file in the theme.

Permalink Reply by David Rutten on January 11, 2015 at 5:46am

Nah it still contains a plugin component I don't have.

But if you want to show all the angles between adjacent edges in a mesh, you can take the following approach:

Attachments:

• SpaceFrame2.gh, 11 KB

Permalink Reply by Gotzman on January 11, 2015 at 8:41am

David, thank you very much for your reply

I use the lunchbox plugin. Angles to the grid is clear how to do, I do not know how to make the angle of lines intersecting at a single point in space.

Attachments:

• SpaceFrame21.gh, 11 KB

Permalink Reply by patric guenther on January 14, 2015 at 12:17am

Hi David,

thank you for your post. I wrote a very similar definition in the past. But what I needed were the angle values as numbers. To check if there are some angels under a specified threshold. I had to do a huge work around to get them. I was wondering if there is a way to add an Output Parameter to the Dimension Components?

Permalink Reply by patric guenther on January 14, 2015 at 1:48am

Permalink Reply by Gotzman on January 16, 2015 at 1:21am

colleagues,
Is it possible to show that both corners in the spatial structure and show tsvvetom angles less than 50 degrees for example??

paneling tools http://www.grasshopper3d.com/group/panelingtools

Attachments:

• line1.3dm, 265 KB
• sf2.gh, 15 KB