New grasshopper component test

Replies to This Discussion

Permalink Reply by Daniel González Abalde on October 7, 2014 at 10:13am

Unfortunately, with polylines fails frequently.

But for splines improves, although you must adjust the angle.

Attachments:

• custompipe_betad.gh, 22 KB

Permalink Reply by Valentin on October 7, 2014 at 10:36am

Post your answer to mcneel forum. I am tested standart pipe component same problem but if you change curve directions the problem is disappear.

Permalink Reply by Valentin on October 7, 2014 at 1:03pm

Do not forget to participate in testing