Grasshopper

algorithmic modeling for Rhino

question about move and Anemone

Hi everyone,

I met a problem and can not find the solution , hope can get help from you .thanks.

Here's the simplest case like this .
Move component is based on the initial object ,but  if I want to move a object based on the last result ,how to get it .

I suppose that componet  Anemone can be used in this situation ,the limit is the distanse is unchangeable ,if the distance is variable , it seems impossible .

Views: 897

Attachments:

Replies to This Discussion

Permalink Reply by Daniel González Abalde on September 27, 2014 at 5:43am

You can multiply each iteration with a value, more iteration more distance.

Permalink Reply by Wang Song on September 27, 2014 at 7:04am
Hi Daniel.

thank you so much.
I tried it and it works.
Permalink Reply by Wang Song on September 27, 2014 at 4:39pm

Actually  the compelet question is this ,hope you can have l look . Thank you agian .

http://www.grasshopper3d.com/forum/topics/question-about-move-based...

Permalink Reply by Pieter Segeren on September 27, 2014 at 5:43am

Hi Wang, use the Mass Addition component:

Permalink Reply by Wang Song on September 27, 2014 at 7:07am
Hi Pieter.

thank you for you introduction of mass addition. it's useful in such a situation.
Permalink Reply by Wang Song on September 27, 2014 at 4:39pm

Actually  the compelet question is this ,hope you can have l look . Thank you agian .

http://www.grasshopper3d.com/forum/topics/question-about-move-based...

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service