Surface from curves

I lofted surface in grasshopper but i wanted it to make by sweep as I have the section curve which is in the middle. I dont know why it won't work. Many thanks!

I have another file with the shape from curves and I have problem with making surface from it as the shape is bit complicated. What would you advise :

1. create shape using rhino +tsplines

is it possible to put surface made by tsplines into grasshopper to make the panels and truss?

2. make it in grasshoper but this kind of shape doesnt work with loft or sweep

Attachments:

FORUM.JPG, 102 KB

Replies to This Discussion

Permalink Reply by Blisza on September 17, 2014 at 5:57pm

I upload this shape from curves. I really just need an advice how to begin with as my long attempts doesnt work at all

Attachments:

surface.3dm, 40 KB

Permalink Reply by ng5 Alex on September 18, 2014 at 8:21am

Hello

you need patch component found in tab surface/freeform/patch

cheers

alex

Permalink Reply by Blisza on September 18, 2014 at 11:39am

Thank you a lot for this, I'll start from it ! Didn't use this component before and I didnt come across in any tutorial.

Is it possible to distribute those points on such surface and latr make panels on it ? For sure it would be quicker to use lunchbox or paneling toold, but is it complicated to use those which I created?

Maybe it would be better to just draw lines in rhino and then put grid on baked surface

Permalink Reply by ng5 Alex on September 18, 2014 at 11:52am

What points? rhino and gh file do not seem to have any points .

RSS