Mesh Patch on Grasshopper

Replies to This Discussion

Permalink Reply by David Rutten on March 21, 2010 at 2:25pm

Not quite like MeshPatch, but you might be able to use the Delaunay component to achieve a similar result.

--
David Rutten
david@mcneel.com
Poprad, Slovakia

Permalink Reply by Arthur Mamou-Mani on October 26, 2010 at 4:44am

Thanks David !

The main advantage of MeshPatch is that it doesn't create extra-faces at the edge.
It would be nice to have a similar control over the delauney.

Delauney:

Mesh Patch:

Permalink Reply by Arthur Mamou-Mani on October 28, 2010 at 4:27pm

Would there be any other technique to prevent from having these unwanted mesh faces at the edge ?
Many thanks,
Arthur

Permalink Reply by Ognek Kciroks on October 28, 2010 at 5:07pm

hey arthur,

this worked for me in my work.
perhaps it would work for you too.

ognek

Attachments:

• fake minimal surface.ghx, 117 KB

Permalink Reply by Arthur Mamou-Mani on October 28, 2010 at 5:13pm

Thanks Ognek for the fake minimal surface :)
I have a lot of edges to apply this on that's why i thought mesh patch would probably take less memory...

Permalink Reply by Arthur Mamou-Mani on October 28, 2010 at 5:33pm

If there was a mesh split I could actualy split the delauney using the edge curve...
I couldn't find a scripting method for either both unfortunately