Smoothing Voronoi Mesh

Hello there I was wondering if I could get some help.

I am currently designing fully configurable Voronoi panels. I almost have what I need ready ( .gh file attached ), but im having a bad time trying to smoth the inner edges of the voronoi. I got an example of what I want manually with 3Dmax ( picture attached ) but i can´t work it out in the Grasshopper parametric file.
Each hole needs to have a rounded Edge, and the Smooth Mesh does not makes any change on those edges.
I Need the edges of the block to be straight, because the panels will be 3D Printed and they will stack one on top of the other.

I searched the forum but didn´t seem to find the answer.
Any kind of help/advice will be much apreciated.

Thanks.

Attachments:

Replies to This Discussion

Permalink Reply by Daniel González Abalde on August 12, 2014 at 1:47pm

http://www.giuliopiacentino.com/weaverbird/

Smoothing meshes plugin for rhino and gh

Permalink Reply by Damon on August 12, 2014 at 2:05pm

Yup, that's the way to go... here's a try, but it doesn't look as nice as what you got from 3ds. But I don't work with meshes, much, so I'm probably missing something obvious.

Attachments:

VoronoiBlock2.gh, 14 KB

Permalink Reply by Alvaro on August 12, 2014 at 2:21pm

Thank you So much! Thats what I was willing to get!!!

Permalink Reply by Michael Pryor on August 12, 2014 at 3:21pm

If you would like it to be really nice and smooth I think there is a few important steps. Looking at the image you attached the outer wall in flat and the inner walls are smoothed, so here I separate them until the end. Also, it's important to weld the mesh we want to smooth. Then we will smooth it while setting naked edges to be fixed so they stay straight. Then after smoothing we join back the outer walls. This way the mesh wont have this very fine bumpiness up close but it will achieve an overall smooth object.

Attachments: