Controlling points along a curve - beginner

I would like to place points along a curve and control where they start and the distance between them.

I've seen how this is done with points in space but unsure how to map it along a curve.

Any help greatly appreciated.

Thanks

Adam

Replies to This Discussion

Permalink Reply by Angel Quintana on July 4, 2014 at 1:03pm

Like this? o_0?

Attachments:

Controlling points along a curve.gh, 10 KB

Permalink Reply by Adam David Hills on July 4, 2014 at 1:38pm

amazing, thanks!

Permalink Reply by Adam David Hills on July 6, 2014 at 5:08pm

From this position I would now like to add a vertical parallel plane at each point that respects the vector direction, ie plane follows line. If you can imagine the curve Angel has drawn is a plan of a viaduct and each point will become an arch that I will boolean out. What is the simplest way to get the plane vertical? I've managed to align them but not sure which button I need to flip the plane upright. I will draw the arch profile in rhino and orient it to the planes at each point. Any suggestions?

Thanks a lot!

Permalink Reply by Angel Quintana on July 7, 2014 at 1:05pm

Permalink Reply by Adam David Hills on July 7, 2014 at 4:04pm

Thanks a lot for your help! whereabouts did you find that final rotate? my rotate has G-A-P as input and not G-C-F-T. I think I have a different version?? as DePlane is now pComp too.

Permalink Reply by Adam David Hills on July 8, 2014 at 12:19pm

cool, upgraded and found it. Thanks a lot for your help.

RSS