Can't change wire display on Point On Curve component

Replies to This Discussion

Permalink Reply by David Rutten on June 25, 2014 at 3:21am

Piffle! Of course it can be done. Just put this:

<item name="WireDisplay" type_name="gh_int32" type_code="3">2</item>

underneath this:

<item name="SourceCount" type_name="gh_int32" type_code="3">1</item>

in the clipboard xml.

--

David Rutten

david@mcneel.com

Permalink Reply by Andrei Raducanu on June 25, 2014 at 4:25am

if i only knew which one the "clipboard xlm" is....

Permalink Reply by David Rutten on June 25, 2014 at 4:30am

You copy a slider, paste in Notepad, edit the Xml, copy the changed Xml, then paste in Grasshopper again.

I'm not seriously suggesting this is how one ought to set wire display, it was just a joke response to your "it can't be done i tell you!"

--

David Rutten

david@mcneel.com

Permalink Reply by Andrei Raducanu on June 25, 2014 at 5:05am

yeah, i know, but i thought it would be interesting to try out (and it was)

thanks!