Save V-Ray Renderings via Grasshopper

Replies to This Discussion

Permalink Reply by David Rutten on June 15, 2014 at 3:19am

Typically there's a Rhino command you can run to save a file. For regular rhino and brazil renderings it's _SaveRenderWindowAs

--

David Rutten

david@mcneel.com

Permalink Reply by Tobias on June 16, 2014 at 2:55am

Hey David,

thank you very much it worked well!

What doesn't work is to insert a file name.

It works when I type it by hand or paste it to the command line but it doesn't if I try to do it by a text in grasshopper. Any Ideas?

Best regards,

Tobias

Attachments:

• insert name.PNG, 162 KB

Permalink Reply by David Rutten on June 16, 2014 at 4:53am

I'd try:

-_SaveRenderWindowAs "C:\bake\torus.png"

Seeing as how it's basically a single command.

--

David Rutten

david@mcneel.com

Permalink Reply by Tobias on June 17, 2014 at 6:49pm

Great,

I tryed "...", too but had seen them as different commands.

One last question about this topic:

Is it possible to assign v-ray materials to a rhino layer via commends? the console only shows me v-ray edit after doing this by hand.

Best regards,

Tobi

Permalink Reply by Tobias on June 18, 2014 at 2:05am

Hey David,

I tryed it today and what happens is in the attached file.

The render image will be saved before the rendering is done. do I have the chance to listen to v-ray about its progress?

best regards,

Tobi

Attachments:

• sphere.jpg, 10 KB