when you have Pull Point, why need others...?

Hi!

i was just wondering what's the use of the CP, Srf CP, Crv CP components, when you have the pull point command that practically accepts any geometry as input (including points, curves and surfaces)

thanks

Replies to This Discussion

Permalink Reply by David Rutten on October 20, 2010 at 4:54pm

Hi Andrei,

you might want to know more about the curve AT that closest point. What if you wanted to know the curvature at the curve at that location? You need the curve parameter to get that far. Only CurveCP will get you there.

--
David Rutten
david@mcneel.com
Poprad, Slovakia

Permalink Reply by Vicente Soler on October 20, 2010 at 4:54pm

Usually (at least for me) you want the curve parameter or the uv coordinate that corresponds to the closest point, and not the actual closest point. Those outputs are not there in pull point.

Permalink Reply by Andrei Raducanu on October 21, 2010 at 11:32am