Grasshopper

algorithmic modeling for Rhino

Small wish re: connection wire colors

Is there any way to prevent wires from changing colors over their length?  For instance, if I select a component and want to follow the wire to see what in connects to, the green gradually becomes gray, like all the other wires and I can't see where it goes.

Thanks!

dh

Views: 306

Replies to This Discussion

Permalink Reply by David Rutten on April 16, 2014 at 2:40am

The attached file will set the wire colour (both ends) for selected wires. This setting should be the default the next time you start Grasshopper.

--

David Rutten

david@mcneel.com

Attachments:
Permalink Reply by Declan Halpin on April 16, 2014 at 6:24am

David - you are the best.  Thanks!

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service