Grasshopper

algorithmic modeling for Rhino

loops

Im new to using grasshopper and am trying to perform a series of actions on a  geometry, and then the same set of actions on the resultant geometry, over and over in a loop.  Does anyone know if it possible to do this in grasshopper without copying and pasting the series of actions 100s of times?  if not is it possible to create a loop in a vb script which could control the grasshopper script actions?

Views: 332

Replies to This Discussion

Permalink Reply by Mårten Nettelbladt on October 5, 2010 at 3:37pm
There is no Loop component (yet) you will need to use the VB Script component (under Math>Script).
Permalink Reply by taz on October 6, 2010 at 9:00pm
Just remembered that Andrew Heumann posted something about this recently:

http://heumanndesigntech.wordpress.com/2010/08/13/iteration-in-gras...

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service