data conversion failed from plan to surface

Replies to This Discussion

Permalink Reply by Kaz on March 3, 2014 at 2:52am

any help !? :(

Permalink Reply by Danny Boyes on March 3, 2014 at 3:09am

Rather than trying to convert a surface into a plane (btw I don't know why it is failing) you can use [Evaluate Surface] to create a plane at any point such as the middle. ((0.5, 0.5) of a reparamaterised surface)

Or you can create planes from Lines and points such as a specific edge and the opposite point. This will allow you to orientate the planes specifically.

 

Permalink Reply by Kaz on March 3, 2014 at 7:56am

thank you Danny ! , i will try it now ...

Permalink Reply by David Rutten on March 3, 2014 at 4:04am

I don't have Lunchbox installed so I cannot test why it fails. Typically a conversion from surface to plane fails if the surface is not planar. If you can internalise the surfaces and post only that data I can have a more detailed look.

--

David Rutten

david@mcneel.com

Permalink Reply by Kaz on March 3, 2014 at 7:53am

thank you so much David !!

Attachments:

• ka17.gh, 588 KB

Permalink Reply by David Rutten on March 3, 2014 at 8:09am

I really meant just one surface parameter which has all the data inside of it. Like so:

The file you posted still has non-standard components.

--

David Rutten

david@mcneel.com

Permalink Reply by Kaz on March 4, 2014 at 12:47pm

i think i 've got it , sorry for misunderstanding , 

Attachments:

• ka18.gh, 47 KB

Permalink Reply by MARIO VERGARA on March 4, 2014 at 12:56pm

unfold panels

Attachments:

• ka18_2.gh, 20 KB

Permalink Reply by Kaz on March 4, 2014 at 1:24pm

thank you so much Mario !!

greetings from Syria !